How to fix display port no signal issue after applying new thermal paste?
I have recently replaced the old thermal paste on my CPU and GPU using the buttered toast method and arctic mx 6 paste. I made sure there was no spillage or damage to the components. However, when I tried to boot my PC, the monitor showed no signal from the display port. I also could not turn off the PC from the power button. I have tried the following troubleshooting steps, but none of them worked:
Checking for bent CPU pins
Checking for faulty GPU connection to the motherboard
Reinserting CPU, CPU cooler, GPU and RAMs to the motherboard
Reinserting motherboard, CPU and GPU cables from PSU
Using a HDMI cable instead of display port
Removing CMOS battery and holding the power button for 30 seconds
Cleaning dust with hair dryer
Loosening screws of CPU cooler
Booting PC without CPU cooler
What
could be the cause of this problem and how can I fix it? Any suggestions would be appreciated.
https://technsight.com/
What to Do When Your Monitor Goes Black After Replacing Thermal Paste
Moderator: weldonmc
-
- Posts: 1
- Joined: Wed Feb 14, 2024 1:02 pm
- Location: Indonesia
- Contact:
-
- Posts: 56
- Joined: Fri Apr 12, 2024 4:28 pm
- Location: Jordan
- Contact:
lolita porn.
What measures are in place to prevent inappropriate content like "lolita porn" from being posted on the forum, and how can users report such content if they come across it?